CENTRALIZED LUBRICATION

• Hand pump for the lubrication of all bearings and a better maintenance of the machine.
• Option for RCE, included in standard configuration for all RCS and R4C.

HARDENED ROLLS HF

• Hardness 50/60 HRC (8 to 10 mm deep)
• Avoid the marking or damages of the rolls

CONE DEVICE FOR CONICAL BENDING

• Used to control the sliding of the sheet during the cone bending process
• Heat treated thrust set up under the top roll
• Included in standard configuration for R3h from 90 to 170. In option for the others R3h, R3e and R4h

HYDRAULIC CONTROL OF OPENING YOKE

•  Easy removal of closed parts.
• Opening by a hydraulic jack.
• In standard configuration for R3H with roll’s diameter ≥ 175 mm and R4C.
•  In option for the other R3H. Not available on R3H <130mm (Electric in option ).

SPECIAL MOTORIZATION

If necessary, Picot can boost the motorization of the machine to meet the customer’s requirement.

OIL COOLER

• To cool the hydrauiic oil of the machine in hot environments.
• In standard for the machines with rolls
  ≥ 325 mm

AUTOMATIC CENTRALIZED LUBRICATION

• In standard configuration for all machines with a roll’s diameter ≥400 mm. 
• In option for the smallest machines to replace the manual pump.

PRE-EQUIPMENT FOR PLATE TRACKER

This equipment must be provided at the construction of the machine if an installation of a plate tracker is planned later.

PRE-EQUIPMENT FOR TOP SUPPORT

This equipment must be provided at the construction of the machine if an installation of a top support is planned later.

POLYAMIDE ROLLS

•  To roll sheet-metal cassettes.
• Roll simultaneously several cassettes.

Automatic Laser Profile Measurement

Automatic profile measuring technology based on laser vision. This technology, combined to AIR module helps dealing with live correction.

Interchangeable top roll

For the 100% electric version, the machine can be supplied with a roller of a different diameter. It is then equipped with an integrated quick-change tool (10 minutes) and, optionally, a storage drawer.

Plate Tracker

• Plate tracker to support large metal sheets
• 2 axes articulation with two double effect cylinders. Reaches any position
• Available in power 500 kg or 1000 kg

Top support

• To hold your rings of large diameter
• Dimensions ot the arm and power according to the requirement.

Bending diameter direct measuring system

• Outer & inner diameters
• Two types of support

FEEDING TABLE

• Helps loading large sheets
• Helps loading multiples sheets

Lifting Package

• For small machine, we have developed a full package with top et side supports at affordable cost.
• Top and side support can be offered separatly.